Main equipment: sewage pump, grille, rotary brush aerator, submersible pusher, sludge return pump, scraper suction machine, press, etc. During the construction, it is often found that when the metal engraved board is installed, it will be neatly arranged, basically there is no gap. This is because it uses the chamfering process in production. Below Jinan Dubai, we will introduce it to you. .

1. For the installation of ventilation equipment or through the pipeline, you can leave the hole on the board properly. In order to minimize the influence of the hole on the structural performance of the prestressed metal engraved plate, the longitudinal direction of the hole should be parallel to the direction of the plate, or a small hole should be used in order to minimize the breaking of the prestressing tendon. When there are many holes, it is better to arrange along the direction of the plate and place it in the sheared area of the plate as much as possible. If possible, it is best to arrange the holes in the middle of the two prefabricated panels.

2. The chamfering treatment of the metal engraved board In the mixed structure, the design of the slab is often affected by the fact that the structural column cannot be disconnected between the floors. At this time, the method of cutting the corner of the sheet can be taken to solve the problem. In general, the width of the chamfer should not exceed one quarter of the width of the panel. When the width of the metal engraved plate is more than one quarter of the width of the board, special treatment measures should be taken, such as setting the calf leg or other support on the bottom beam.

The chamfering process of the metal engraving board makes the board more tidy, so that when building a building, not only can it increase its safety, but also improve the efficiency of the entire building.

In the architectural decoration, the metal carved insulation board can be widely used, mainly because its pattern is exquisite, and the texture is thin and light, and the glue is used to fix it. We should pay attention to the following points.

1. The composite surface of the metal carved insulation board must be flat to improve the composite bonding strength and reduce the amount of glue used.

2, the adjustment ratio must be accurate, the glue must be stirred evenly.

3. In order to ensure the pressure of the composite quality coating, there must be a certain outflow of glue.

4, before the glue is not cured, can not move the metal carved insulation board.

5, the glue must be used now, after the glue must be used up within the available time.

6. The construction temperature should not be lower than 5 °C and the humidity is less than 70%.

7. Do not mix the large parts of the glue with different components, and evenly put the remaining glue after mixing into the package.

The architectural decoration can not be separated from the use of a variety of metal carved insulation boards, which are fixed by glue, and the glue is evenly distributed so as to be fixed for a long time.