Nowadays, there are many applications of metal-carved insulation boards on many buildings, which greatly reduces the pollution problems caused by traditional wall panels to the living environment, and also has a good insulation function. In the process of use, There is no problem with the metal engraved board. Metal engraved insulation board manufacturers also need to pay attention to a lot of details. We will take you to the specifics below.

1. The bottom surface of the transporting tool should be flat. After horizontal loading, the carved plate should be fixed to avoid damage to the product due to excessive binding of the carved plate during the fixing; reduce vibration during transportation and prevent collision and rain. The environment in which the engraved panels are placed should be ventilated and dry, and the site must be flat and solid.

2. When the metal engraved insulation board manufacturers carry the engraved board and load and unload the engraved board, the length direction of the board should be used as the force side, carefully transported to avoid damage and damage the board; when transporting a single sheet, the board should be erected. So as not to cause deformation of the board.

3. When using square wood support pads, ensure that the products are not deformed; when placed in the open air, the carved plates should be completely covered with tarpaulins; when the metal carved insulation board manufacturers store the carved plates, they should be away from high temperature and high humidity areas, and should not be mixed with oil. Chemicals and other corrosive materials should be mixed and stored. When opening the engraved board packaging, it should be placed flat, then unsealed from the top of the product packaging, and the board should be taken out from top to bottom.

4. Do not open the engraved board from the side to avoid scratching the board surface. After the engraved board is cut, the surface of the board and the incision will be attached with cutting iron filings, which are easy to rust. The remaining iron scraps should be removed.

5. For the railings protruding from the wall, the air-conditioning wall pipe and the condensing water pipe, etc., the metal-carved insulation board manufacturers should reserve the corresponding size before the board is installed. Do not open the hole after the board is installed. If the wall surface has The supporting members of air conditioners, exhaust vents, etc., should be carried out before the wallboard and insulation materials are laid.

6, metal carved insulation board manufacturers should pay attention to protect the carved board surface when construction, to avoid scratching and impact, to avoid construction work when it rains; during the construction process, to prevent the interior of the carved board from contact with water, so as to avoid internal water from the surface Exudation, causing corrosion and rust on the surface of the board, reducing the life of its use, avoiding use in high temperature, high humidity, and acid discharge (such as boiler room, combustion chamber, hot springs, paper mills, etc.). [For details, please refer to the relevant content of "Analysis of the performance of metal carved panels"]

About the use of metal carved insulation board, I will explain it to you first. After reading the article, if you have the need to buy insulation board, you can directly contact our metal carved insulation board manufacturer, we will definitely do it for you. Provide products that will satisfy you.